  |
 |
         |
|
       |
|
      |
|
| From here, in addition to using the riffler to debur, all parts should be run slightly across some 320 or 400 grit sandpaper to catch any dirt or small burs, etc. This assures cleanliness, flatness, and precision. This step will be followed periodically throughout the construction of the knife. Not following this step, may contribute to parts not mating up properly. |
|
|
|
|
|
|
|
All Work Designed, Executed, and ©1998-2005 by John Lewis Jensen, unless otherwise credited. All Rights Reserved. |